Heating Tune Up in Tupelo, MS

The heating tune up checklist

• Full ignition sequence run and observed
• Igniter condition and resistance checked
• Flame sensor cleaned and flame signal measured in microamps
• Burner flame quality and gas pressure verified on gas equipment
• Heat exchanger inspected for cracking and corrosion where accessible
• Inducer motor, pressure switch, and venting inspected
• Blower cleaned as needed and amp draw measured
• Static pressure and temperature rise measured against specification
• Safety controls including limits and rollout switches tested
• For heat pumps: heating mode, reversing valve, defrost cycle, and backup heat stages

Combustion safety is not optional

Any visit on a gas appliance includes combustion safety. That means inspecting the heat exchanger, confirming the vent draws properly, verifying combustion air, and testing the safety devices that shut the appliance down when something is wrong.

If something is unsafe we say so directly and shut it down, regardless of what that means for the rest of the visit.